designfrat

 Step by step instructions to make this long sleeve blouse pattern

Section 01 : 
 Front & Back Blouse pattern

Draw a square in to below measurements, For Front and back top section
AB / CD- 24 cm
AC / BD - 64cm

BM -  Mark 3cm and square up to point N. This is the shoulder slope.

AK - Neck width 11cm and mark point K.4

AN - Back neck drop 4cm  ,  And draw the neckline as shown in the diagram
FO - Front neck drop 8cm , And draw the neckline as shown in the diagram

NL - Shoulder width 18.5cm and marl point L. Connect point K & L for the shoulder line. 

AI / BJ - mark 15cm and square up. 

IQ -  Across front - 16cm

IP -  Across Back - 18cm

LF - Armhole straight 21cm and mark F . 

FE - Square up F point to meet the point E which is the bust level. 

LQF - Draw Front armhole curve as shown in the diagram.

LPF - Draw Front armhole curve as shown in the diagram.  

IG / JH - waist level 23cm

GR - Waist - 22cm 

SD - 1.5 cm

DT - 4cm 

CT - Curve the bottom hem line as shown in the diagram

FRT -  Connect these pints and draw the blouse side seam as shown in the diagram. 

Section 02 : 
Sleeve pattern

AB - 38cm , Draw Horizontal line 

CD - 52 cm Draw Vertical line

CM -  Sleeve crown height 12cm

Connect ACB points to draw the sleeve shape.

Mark below points and draw the sleeve front & back curve shape as shown in the diagram.

 For Back curve:

Point G - Down 1cm

Point H - Up 1cm  

Point I - Up 2cm

 For Front curve:

Point J - Up 2cm

Point K - Up 1cm  

Point L - Down 2cm

  

EF -  Sleeve open 28cm 

Connect AE / BF  of the side seams of the sleeve. 

Make sure to add 1cm seam allowance to all the pattern pieces after you made them. 

*** Make sure to click on the Image for a better view ***